HP ProLiant SL4545 HP ProLiant SL4500 Series Chassis Maintenance and Service G - Page 37
Power supplies, Management module
View all HP ProLiant SL4545 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Power supplies Before removing the component, be sure to do the following: • Verify the status of the power supply to be replaced by reviewing rear panel LEDs and buttons. • Be sure that your configuration can support your actions. If the proper redundancy is not in place, power down the nodes before beginning this procedure. To remove the component: 1. Disconnect the AC power cord from the AC outlet and the power supply. 2. Remove the component as indicated. To replace the component, reverse the removal procedure. Management module CAUTION: To avoid loss of data, back up all data and power down the node before removing the management module. To remove the component: 1. Power down the nodes ("Power down the node" on page 30). Removal and replacement procedures 37