HP ProLiant SL4545 HP ProLiant SL4500 Series Chassis Maintenance and Service G - Page 58
Rack rail adapter kit
![]() |
View all HP ProLiant SL4545 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Rack rail adapter kit WARNING: The chassis is very heavy. To reduce the risk of personal injury or damage to the equipment: • Observe local occupational health and safety requirements and guidelines for manual material handling. • Remove all installed components from the chassis before installing or moving the chassis. • Use caution and get help to lift and stabilize the chassis during installation or removal, especially when the chassis is not fastened to the rack. WARNING: To reduce the risk of personal injury or damage to the equipment, you must adequately support the chassis during installation and removal. WARNING: Always use at least two people to lift the chassis into the rack. If the chassis is being loaded into the rack above chest level, a third person must assist with aligning the chassis with the rails while the other two people support the weight of the chassis. Rack rail adapters are only available on racks that are pre-configured in the factory. WARNING: Only authorized technicians trained by HP should attempt to replace this component. To remove the component: 1. Remove all chassis attached to the adapter rails ("Remove the chassis from the rack" on page 31). Removal and replacement procedures 58
![](/manual_guide/products/hewlettpackard-proliant-sl4545-hp-proliant-sl4500-series-chassis-maintenance-service-guide-a1759f7/58.png)