HP R1500 HP UPS R5000 User Guide - Page 21
Connecting the USB communications port, Connecting the REPO port, WARNING, IMPORTANT
View all HP R1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
b. Click Scan for hardware changes to refresh the screen and display the changes. Connecting the USB communications port NOTE: This port is only used for firmware upgrades. For additional information, see "Updating the UPS firmware (on page 43)." Connecting the REPO port WARNING: The pins on the REPO port are polarity sensitive. Be sure to verify polarity while connecting the REPO port. WARNING: To meet the requirements stated in NEC (NFPA 70) Articles 645-10 and 645-11, a UPS installed in a computer equipment room must be connected to a REPO circuit. IMPORTANT: The remote switch must be in the Off (open) position to enable power to the output receptacles. Installation and configuration 21
Installation and configuration 21
b.
Click
Scan for hardware changes
to refresh the screen and display the changes.
Connecting the USB communications port
NOTE:
This port is only used for firmware upgrades. For additional information, see "Updating
the UPS firmware (on page
43
)."
Connecting the REPO port
WARNING:
The pins on the REPO port are polarity sensitive. Be sure to verify polarity while
connecting the REPO port.
WARNING:
To meet the requirements stated in NEC (NFPA 70) Articles 645-10 and 645-11, a
UPS installed in a computer equipment room must be connected to a REPO circuit.
IMPORTANT:
The remote switch must be in the Off (open) position to enable power to the output
receptacles.