HP Server rp8420 HP 9000 rp8420 Server - User Service Guide, Fifth Edition - Page 49
Top and Side Cover Installation, Removing the Top Cover
View all HP Server rp8420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Top and Side Cover Installation NOTE: It might be necessary to remove existing top and side covers installed on the server before installing the covers shipped with the wheel kit. If cover removal is not needed, go directly to the sections for installing the top and side cover. Figure 2-14 Cover Locations CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety precautions could result in damage to the server. Removing the Top Cover 1. Connect to ground with a wrist strap. 2. Loosen the blue retaining screws securing the cover to the chassis. 3. Slide the cover toward the rear of the chassis. 4. Lift the cover up and away from the chassis. 5. Place the cover in a safe location. Wheel Kit Installation 49