HP StorageWorks 2/128 HP StorageWorks Core Switch 2/64 and SAN Director 2/128 - Page 126
Setting up a remote modem system, Remote modem setup
View all HP StorageWorks 2/128 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Setting up a remote modem system After the modems are connected, you can use a telco system to dial in to the modems and verify that they answer and communicate as expected. If a dial-out modem facility is not available, you can use a terminal emulation program on a computer workstation (or laptop) that has an attached modem. This procedure is required only if a dial-out modem facility is not already available for testing the Core Switch 2/64 or SAN Director 2/128 modem connections. To set up the optional remote modem: 1. Connect the remote modem to the workstation, as shown in Figure 30. 2. Disable any serial communication programs running on the workstation (such as a synchronization program for a PDA). Analog Telco PC or Laptop running Hyperterminal Rem Mo DB-25M to DB-9F Modem Cable 2.016 Figure 30 Remote modem setup 3. Launch the terminal emulator application and configure as described in Table 18. NOTE: Configuration information in Table 18 applies to most Windows systems. 126 Setting up and installing modems