HP StoreOnce D2D4324 HP D2D Gen2E Backup Systems Maintenance and Service Guide - Page 14

J27 settings (HP D2D4106/4112 and HP D2D2502/2504), After replacing the motherboard

Get HP StoreOnce D2D4324 PDF manuals and user guides View all HP StoreOnce D2D4324 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

3. Enter the Smart Array POST ORCA utility by pressing [F8] when advised during the POST messages. 4. Select the Manage Licenses option in the Smart Array menu, and then select View Licenses. 5. Make a note of the licence key reported. This key is unique to the system and can be used for any replacement Smart Array card (or HP D2D4312 motherboard). J27 settings (HP D2D4106/4112 and HP D2D2502/2504) NOTE: This section is not relevant for HP D2D4312 models. The following diagram shows the location of the J27 jumper on the motherboard. Figure 7 Location of the J27 jumper 1 J27 jumper When replacing the motherboard on HP D2D4106/4112 models or on HP D2D2502/2504 models, set the jumper as follows. Table 2 J27 jumper settings D2D Backup System HP D2D4106/4112: Remove all jumpers HP D2D2502/2504: Jumper should be set on pins 1 and 2 After replacing the motherboard For all Gen2e products you must: 14 Replacing the system motherboard

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
3.
Enter the Smart Array POST ORCA utility by pressing [F8] when advised during the POST
messages.
4.
Select the Manage Licenses option in the Smart Array menu, and then select View Licenses.
5.
Make a note of the licence key reported. This key is unique to the system and can be used
for any replacement Smart Array card (or HP D2D4312 motherboard).
J27 settings (HP D2D4106/4112 and HP D2D2502/2504)
NOTE:
This section is not relevant for HP D2D4312 models.
The following diagram shows the location of the J27 jumper on the motherboard.
Figure 7 Location of the J27 jumper
J27 jumper
1
When replacing the motherboard on HP D2D4106/4112 models or on HP D2D2502/2504
models, set the jumper as follows.
Table 2 J27 jumper settings
D2D Backup System
HPD2D4106/4112:
Remove all jumpers
HP D2D2502/2504:
Jumper should be set on pins 1 and 2
After replacing the motherboard
For all Gen2e products you must:
14
Replacing the system motherboard