HP Vectra VEi8 HP Vectra VLi8, 3 COM Etherlink III ISA 10BT Card, Installatio - Page 12
Microsoft Windows 95, SR2.5, Connecting to a NetWare, 11 Server, Requirements, Device Configuration
View all HP Vectra VEi8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
4 Installing the 3COM EtherLink III 3C509B ISA 10BT Network Adapter Microsoft Windows 95 SR2.5 4 Installing the 3COM EtherLink III 3C509B ISA 10BT Network Adapter Microsoft Windows 95 SR2.5 Connecting to a NetWare Requirements 4.11 Server • HP Vectra with Windows 95 SR2.5. • 3COM EtherLink III 3C509B-TP ISA 10BT network adapter and drivers disk version 6.0. • Driver File: ELNK3ND3.SYS, version 5.26.31 • Microsoft Windows 95 SR2.5 media. • Novell NetWare 4.11 Server that supports IPX network protocol. • Novell Client for Windows 95 v2.5 installation media. Device Configuration Device Configuration Interrupt I/O Address Vectra Vli8 05 210 Vectra VEi7 03 210 Vectra VEi8 07 210 Procedure 1 Power on the system and start Windows 95SR2.5. 2 From the 3COM 3C509B driver disk, run PREINSTL.EXE. 3 Shutdown and power down the system. With the HP Vectra turned off, install the 3COM 3C509B network adapter into an ISA slot. 4 Connect network cable media to the 3COM 3C509B network adapter. 5 Power on the system and press SHIFT- to boot to Windows 95 command prompt. 6 Insert the 3COM 3C509B driver disk and execute "3C5X9CFG.EXE". 7 Select "CONFIGURE NIC" and verify the resource settings listed above under the heading "Device Configuration". 8 If changes are required, save those changes and exit.