HP Vectra VEi8 HP Vectra VLi8, 3 COM Etherlink III ISA 10BT Card, Installatio - Page 7
Microsoft Windows 95, SR2.5, Connecting to a, Windows NT 4.0 Server, Requirements, Procedure
View all HP Vectra VEi8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2 Installing the 3COM EtherLink III 3C509B ISA 10BT Network Adapter Microsoft Windows 95 SR2.5 2 Installing the 3COM EtherLink III 3C509B ISA 10BT Network Adapter Microsoft Windows 95 SR2.5 Connecting to a Requirements Windows NT 4.0 Server • HP Vectra with Windows 95 SR2.5. • 3COM EtherLink III 3C509B-TP ISA 10BT network adapter and drivers disk version 6.0. • Driver File: ELNK3ND3.SYS, version 5.26.31 • Microsoft Windows 95 SR2.5 media. • Microsoft Windows NT 4.0 Server system that supports NetBEUI, NWLink IPX/SPX Compatible Transport and NWLink NetBIOS network protocols. • Device Configuration Device Configuration Interrupt I/O Address Vectra Vli8 05 210 Vectra VEi7 03 210 Vectra VEi8 07 210 Procedure 1 Power on the system and start Windows 95SR2.5. 2 From the 3COM 3C509B driver disk, run PREINSTL.EXE. 3 Shutdown and power down the system. With the HP Vectra turned off, install the 3COM 3C509B network adapter into an ISA slot. 4 Connect network cable media to the 3COM 3C509B network adapter. 5 Power on the system and press "SHIFT-" to boot to Windows 95 command prompt. 6 Insert the 3COM 3C509B driver disk and execute "3C5X9CFG.EXE". 7 Select "CONFIGURE NIC" and verify the resource settings listed above under the heading "Device Configuration". 8 If changes are required, save those changes and exit. 9 Remove the 3COM 3C509B driver disk and reboot the system to Windows 95SR2.5.