HP Vectra VL800 hp vectra vl800, upgrade and installation guide for minitower - Page 52
Replacing the System Board
View all HP Vectra VL800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
2 Installing and Replacing Hardware Parts in Your PC Replacing the System Board Replacing the System Board Removing the System Board 1 Switch off the display and PC. Disconnect all power cables and any LAN or telecommunications cables. 2 Remove the PC's cover (refer to page 25). 3 Lay the minitower on its side. 4 Disconnect all cables attached to the system board. 5 Remove the main memory, processor, heatsink and any accessory cards from the old system board (described in this chapter). 6 Remove the screws securing the system board in place. 7 Lift the system board out, being careful not to damage the PC's rear connectors. 52
2
Installing and Replacing Hardware Parts in Your PC
Replacing the System Board
Replacing the System Board
Removing the System Board
1
Switch off the display and PC. Disconnect all power cables and any LAN
or telecommunications cables.
2
Remove the PC’s cover (refer to page 25).
3
Lay the minitower on its
side.
4
Disconnect all cables
attached to the system
board.
5
Remove the main memory, processor, heatsink and any accessory cards
from the old system board (described in this chapter).
6
Remove the screws securing the system board in place
.
7
Lift the system board out, being careful not to damage the PC’s rear
connectors.
52