HP Workstation xw4100 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 239

diagnostic Commands diagnostic moderation set count To set the default interrupt count on the controller, use the diagnostic moderation set count command. ! Caution: Use this command only under the direction of technical support. Syntax diagnostic moderation set count {integer} Parameters {integer} Specifies the value (for example, 700) you want to set as the default interrupt count on the controller. The interrupt count is the number of outstanding requests on the controller needed before the delay time (the time specified by the diagnostic set timer command) takes effect. For example, if the interrupt count is set to 32 and the delay time is set to 10, the controller batches I/O request responses for one millisecond only if there are more than 32 I/Os outstanding in the one millisecond interval. Related Information diagnostic commands: ■ diagnostic moderation set timer (page 8-8) ■ diagnostic moderation show count (page 8-9) ■ diagnostic moderation show timer (page 8-10) 8-7