HP Workstation xw4100 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 72

Adaptec SCSI RAID Software Reference Guide container create raid5 To create a RAID-5 set, use the container create raid5 command. The RAID-5 set must have a minimum of three disks. When creating the RAID-5 set, you must initialize the array parity by using the scrub method (the /scrub switch). Notes If you created a RAID-5 set you can run the list devices command on the NetWare console to verify its creation and then create the necessary NetWare disk partitions and volumes. For information on how to create partitions and volumes, see the appropriate NetWare documentation. Syntax container create raid5 [/cache{=boolean}] [/clear{=boolean}] [/stripe_size{=integer}] [/label{=string}] [/scrub{=boolean}] [/wait{=boolean}] {free_space} [{scsi_device}...] Parameters {free_space} Specifies the SCSI device and its associated freespace used to create the RAID-5 set. See the free_space section on page 3-8 for more information on how to specify the freespace. {scsi_device}... Specifies one or more SCSI devices. A SCSI ID consists of a SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSI device logical unit number (0 through 7 inclusive). See the installation guide for your controller to determine the number of buses it actually supports. See the scsi_device section on page 3-7 for more information on how to specify the SCSI device. 5-24