HP Workstation xw4100 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 99

container Commands Examples Before extending a volume set, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array (volume set) 1 on this controller: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size E: 1 Volume 100MB NTFS 2:02:0 200MB: 100MB Before extending the volume set, you might want to use the disk show space command to display space usage information on the SCSI devices from which you plan to add freespace. The following example extends a volume set by adding freespace from two SCSI devices: AAC0>container extend volume 1 ((2,0,0), 32M) ((2,1,0), 32M) Executing: container extend volume 1 ((CHANNEL=2,ID=0,LUN=0),33,554,432)((CHANNEL=2,ID=1,LUN =0),33,554,432) container 1 expanded. As the command executes, note that the title bar of the DOS window displays the status of the command. For example: Stat:OK!,Task:101,Func:FSX Ctr:0,State:RUN 83.8% See page 3-10 for detailed information on the status information that the command displays in the title bar as it executes the task. 5-51