HP Workstation xw4100 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 59

container Commands Examples Before creating a multilevel array of mirror sets, use the container list command to obtain information about any existing arrays. As the following example shows, array 0 is a volume set that consists of two underlying volume sets created with the container promote command: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 0 Volume 30MB NTFS 63 Volume 15MB 0:02:0 64.0KB: 15.0MB 62 Volume 15MB 0:03:0 64.0KB: 15.0MB The following example shows how to create a multilevel array of mirror sets with the following characteristics: ■ The array specified (0) is a multilevel array of volume sets that was previously created with the container promote command. ■ The freespace from SCSI devices (0,4,0), and (0,5,0) are used to mirror the underlying volume sets. ■ The default I/O delay is taken. ■ The multilevel array of mirror sets is created asynchronously. AAC0>container create mmirror 0 (0,4,0) (0,5,0) Executing: container create mmirror 0 (CHANNEL=0,ID=4,LUN=0) (CHANNEL=0,ID=5,LUN=0) As the command executes, note the title bar of the DOS window displays the status of the command. For example: Stat:OK!Task:101,Func:MCR Ctr:63,State:RUN 97.2% See page 3-10 for detailed information on the status information that the command displays in the title bar as it executes the task. Use the container list command after using the container create mmirror command to display information about the multilevel array of mirror sets: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition 5-11