HP Workstation xw4100 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 53

container Commands container create mirror To create a mirror set from a single-partition volume set and freespace, use the container create mirror command. Any data on the original volume set remains intact during mirror creation and the user sees no interruption in service. If you created a mirror set on a NetWare server, you can run the list devices command on the NetWare console to verify its creation and then create the necessary NetWare disk partitions and volumes. For information on how to create partitions and volumes, see the appropriate NetWare documentation. Syntax container create mirror [/wait{=boolean}] [/io_delay{=integer}] {container} {scsi_device} Parameters {container} Specifies the ID number (0 to 63) of the array on which to create a mirror set. You create a mirror set from a singlepartition volume set. {scsi_device} Specifies the ID for the SCSI device whose freespace you want to use for mirroring the volume set specified in the container parameter. A SCSI ID consists of a SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSI device logical unit number (0 through 7 inclusive). See the installation guide for your controller to determine the number of buses it actually supports. See the scsi_device section on page 3-7 for more information on how to specify the SCSI device. 5-5