HP XP20000/XP24000 HP StorageWorks MPX200 Multifunction Router User Guide (569 - Page 216

SNMP trap configuration parameters SNMP trap configuration lets you set up to eight trap destinations. Choose from Trap 1 through Trap 8 to configure each trap. Table 29 describes the parameters for configuring an SNMP trap. Table 29 SNMP trap configuration parameters Parameter Description Trap n enabled1 Enables or disables trap n. If disabled, the trap is not configured. Trap address Specifies the IP address to which the SNMP traps are sent. A maximum of eight trap addresses are supported. The default address for traps is 0.0.0.0. Trap port1 Port number on which the trap is sent. The default is 162. If the trap destination is not enabled, this value is 0 (zero). Most SNMP managers and management software listen on this port for SNMP traps. Trap version Specifies the SNMP version (1 or 2) with which to format traps. 1Trap address (other than 0.0.0.0.) and trap port combinations must be unique. For example, if trap 1 and trap 2 have the same address, they must have different port values. Similarly, if trap 1 and trap 2 have the same port value, they must have different addresses. Management Information Base This section describes the QLogic MIB. Network port table The network port table contains a list of network ports that are operational on the router. The entries in this table include the management port (labeled MGMT) and the GbE ports (labeled GE1 and GE2). qsrNwPortTable Syntax Access Description SEQUENCE OF QsrNwPortEntry Not accessible Entries in this table include the management port, and the iSCSI ports on the router. qsrNwPortEntry Syntax Access Description QsrNwPortEntry Not accessible Each entry (row) contains information about a specific network port. A network port entry consists of the following sequence of objects: qsrNwPortRole QsrPortRole 216 Simple Network Management Protocol setup