Honeywell 7600BP-121-21EE User Guide - Page 123

Battery Charging, Recommendations for Storing Batteries

Get Honeywell 7600BP-121-21EE - Hand Held Products Dolphin 7600 PDF manuals and user guides View all Honeywell 7600BP-121-21EE manuals
Add to My Manuals
Save this manual to your list of manuals

Page 123 highlights

Battery Charging Inserting and Removing Battery Packs To insert a battery pack, place the end of the battery without the locking tab into the bottom of the charging pocket and snap the battery into place with a hinging motion. To remove a battery pack, push the locking tab down and pull the battery away from the charging slot with a hinging motion. Charging Process The QuadCharger device charges Li-ion battery packs in four hours. Each charging slot works independently of the other three. As battery packs charge, the charging circuitry follows the two-step charging process (CC-CV) that is recommended for Li-Ion batteries. The process monitors changes in temperature, current, and voltage. Temperature The QuadCharger device charges Li-ion battery packs in four hours when charged within the recommended temperature range of 50° to 95° F (10° to 35°C). Temperature has a significant effect on charging. For best results, battery packs should be at room temperature before inserting in the QuadCharger device. When the battery temperature exceeds 40°C, the QuadCharger device may exceed the ! stated four-hour charge time. The QuadCharger device stops charging if the battery temperature is greater than 40°C but will begin charging again when the battery temperature is less than 40°C. To Charge Batteries 1. Supply the QuadCharger device with power and turn the power switch on. 2. Insert batteries into the appropriate slots. The Status LED for each slot turns orange to indicate that the battery is properly seated and has begun a charge cycle. 3. When the Status LED turns green, the battery in the slot has completed charging. Recommendations for Storing Batteries To maintain top performance from batteries, follow these storage guidelines: • Avoid storing batteries outside of the specified temperature range of -4 to 122° F (-20 to 50°C) or in extremely high humidity. • For prolonged storage, do not keep batteries stored in a charger that is connected to a power source. Dolphin® 7600 Mobile Computer User's Guide Downloaded from www.Manualslib.com manuals search engine Rev A 5/23/2008 11 - 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
Dolphin® 7600 Mobile Computer
User’s Guide
Rev A
5/23/2008
11 - 3
Battery Charging
Inserting and Removing Battery Packs
To insert a battery pack, place the end of the battery without the locking tab into the bottom of
the charging pocket and snap the battery into place with a hinging motion.
To remove a battery pack, push the locking tab down and pull the battery away from the
charging slot with a hinging motion.
Charging Process
The QuadCharger device charges Li-ion battery packs in four hours. Each charging slot works
independently of the other three. As battery packs charge, the charging circuitry follows the
two-step charging process (CC-CV) that is recommended for Li-Ion batteries. The process
monitors changes in temperature, current, and voltage.
Temperature
The QuadCharger device charges Li-ion battery packs in four hours when charged within the
recommended temperature range of 50° to 95° F (10
°
to 35
°
C). Temperature has a significant
effect on charging. For best results, battery packs should be at room temperature before
inserting in the QuadCharger device.
When the battery temperature exceeds 40
°
C, the QuadCharger device may exceed the
stated four-hour charge time. The QuadCharger device stops charging if the battery
temperature is greater than 40
°
C but will begin charging again when the battery
temperature is less than 40
°
C.
To Charge Batteries
1.
Supply the QuadCharger device with power and turn the power switch on.
2.
Insert batteries into the appropriate slots.
The Status LED for each slot turns orange to indicate that the battery is properly seated and has
begun a charge cycle.
3.
When the Status LED turns green, the battery in the slot has completed charging.
Recommendations for Storing Batteries
To maintain top performance from batteries, follow these storage guidelines:
•
Avoid storing batteries outside of the specified temperature range of -4 to 122° F (-20 to 50°C) or in
extremely high humidity.
•
For prolonged storage, do not keep batteries stored in a charger that is connected to a power source.
!
Downloaded from
www.Manualslib.com
manuals search engine