Honeywell MK7580-30B41-00 User Guide - Page 13
RS485
View all Honeywell MK7580-30B41-00 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
RS485 1. Turn off power to the host device. 2. Plug the interface cable's modular connector into the socket on the imager. 3. Connect the other end of the cable to proper COM port of the host device. 4. Turn on power to the host device. 5. The MS7580 will start to initialize. The white and blue LED will alternately fade on and off for three seconds. When the imager has finished initializing, the imager will flash the white LED three times while simultaneously beeping three times. The low intensity blue LED will remain turned on. Installation Note Figure 7. RS485 Plugging the imager into a port on the host system does not guarantee that scanned information will be communicated properly to the host system. The imager is shipped from the factory configured with default settings. Please refer to the MetroSelect Single-Line Configuration Guide (PN 00-02544) or MetroSet2's help files for instructions on changing the imager's configuration. In addition, please check that the imager and host system are using the same communication protocol. The MS7580 requires 12V power from the host for RS485 operation. 9