Honeywell NSLAN1 Installation Guide - Page 14

NSLAN1 Ethernet Board Installation Guide NSLAN1 • 6 = 255.255.255.192 • 7 = 255.255.255.128 • 8 = Class C (subnet mask: 255.255.255.0) • 9 = 255.255.254.0 • 10 = 255.255.252.0 • 11 = 255.255.248.0 • 16 = Class B (subnet mask: 255.255.0.0) • 23 = 255.128.0.0 • 24 = Class A (subnet mask: 255.0.0.0) • ... = No subnet mask 10. At the "Change Telnet config password" prompt press ENTER to accept the default value of "N". 11. At the "Your choice ?" prompt, enter "1" to go into "Channel 1 configuration". 12. At the Baud rate prompt, enter "57600" the press ENTER. 13. At the I/F Mode prompt, press ENTER to enter the default value. 14. At the Flow prompt, enter "0" then press ENTER. 15. At the "Port No" prompt, enter "3001" then press ENTER. NStar uses port 3001. 16. Press ENTER for the remainder of the menu prompts. 17. When the Setup Mode window reappears, enter "9" to save and exit. Finally, type "exit" then press ENTER to exit the MS-DOS command window. NSLAN1 Ethernet Board Installation Guide Document TD1164, Revision A 12 © 2005 Honeywell International