Hoover FH50015 Manual - Page 14

3-21 Possible cause Possible solution • Recovery tank full/automatic Make no more than 2 passes with the solution over any one area to prevent over-wetting and damage to fabric. If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again. 11. Empty recovery tank when the motor sound becomes higher pitched and there is a loss in suction (see "Automatic shut-off", page 7). When finished cleaning, follow "After cleaning" instructions on pages 9 and 10 and "After using tool" instructions on pages 12 and 13. Storage Before storing: • Empty solution tank and rinse thoroughly with clean water. • Replace empty solution tank and turn carpet cleaner ON. Squeeze trigger and push carpet cleaner forward and back several times to expel any solution remaining in the carpet cleaner's system. (Do not use carpet cleaner on wood floors.) • Empty recovery tank and rinse thoroughly with clean water. Allow underside of carpet cleaner to air dry thoroughly before storing carpet cleaner on a carpeted or wood surface. Do not store carpet cleaner with a full solution tank In place. Lubrication The motor is equipped with bearings which contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Do not add lubricant to motor bearings. shut off engaged • Remove and empty recovery tank • Blockage In tool on end of hose • Remove tool and clear blockage • Recovery tank lid not on correctly • Make sure lid is on securely • Recovery tank front panel not replaced after stair or upholstery cleaning • Replace recovery tank front panel (page 13) Possible cause Possible solution • Solution tank not firmly in place • Make sure tank is securely locked in position • Solution tank empty • Refill tank according to instructions for surface being cleaned If further assistance Is needed, contact the Consumer Response Center, Phone: 1-330-499-9499. In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone: 1-800-263-6376. Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the bottom of the cleaner.) 14