Hoover FH50015 Manual - Page 6

2. How to use Carpet cleaner description 2-1 10 14 21 19 18 9 11 12 13 15 16 20 17 23 The assembled carpet cleaner will look like the drawing. cord release. 22. Bare floor attachment 8. Powered hand tool 23. Stair/upholstery nozzle 9. Carrying handle 10. Clean solution tank handle 11. Clean solution tank cap/ This carpet cleaner is intended measuring cup for household use. 12. Clean solution tank: holds cleaning solu- Operate carpet cleaner only at tion. 13. Recovery tank lid 14. Recovery tank: holds dirty solution. 15. Recovery tank front panel 16. Hood voltage specified on data plate on back of cleaner. Plug carpet cleaner Into a properly grounded outlet. ON/OFF pedal & Handle release pedal 17. Nozzle 18. Upholstery and stair clean- 22 ing connection: push door open to connect stair/uphol- stery nozzle "solution tube". 19. Recovery tank latches: one on each side of tank. 20. ON/OFF pedal 21. Handle release pedal: Step on pedal (A) to turn carpet cleaner on. Step on pedal again to turn carpet cleaner off. Step on pedal (B) to lower handle to operating position. Handle does not lock into a single position but "floats" to allow convenient operation. To transport step on pedal to To move your carpet cleaner from lower handle to operat- ing (floor) position. 2-2 2-3 2-4 B A room to room put handle in upright and locked position tilt carpet cleaner back on wheels and push forward. The carpet cleaner may also be lifted by placing a hand under the clean solution tank handle as shown. Automatic "shut off" When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the carpet cleaner suction (suction will be noticeably reduced). At that time the yellow float disk will rise to the top of the recovery tank lid (E). The carpet cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch. When this happens turn carpet cleaner off and empty recovery tank before 6