Hoover FH50015 Manual - Page 4
Attach tool holder, Storing hose
View all Hoover FH50015 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Push bolts into holes on front of handle. If 1-2 bolts will not go through hole easily han- dle is not pushed completely down. 1-3 A When handle sections are completely together, squeeze trigger (C) on upper handle to snap trigger rod in place. Replace clean solution tank (upper tank) by 1-4 1-5 B positioning bottom first. Press on tank handle to snap top of tank into place. Press cord into cord clip on back of hose holder. Pull cord tight. Attach hose holder Position hose holder (B) onto handle by 1-6 C The extra nut is not required but has been provided for your convenience. Attach tool holder Remove tool and taped screw from holder. Insert projections on holder into slots on back of cleaner. Slide holder down into place. Insert screw at (D) and tighten with a Phillips screwdriver. Storing hose Stretch hose out and identify ends. E. Nozzle connector end of hose G. Solution tube 1-7 1-8 matching tabs on rack with openings on back of handle. Make sure bolts are through holes. 1-9 D F. Trigger H. Converter end of hose Note: You may find it helpful when storing the hose to refer to the information on the back of the carpet cleaner and on 4 the converter end of the hose. Start with converter end of hose (H). Fit converter over tab near tool holder (I). Press Place nuts in recessed areas on back of hose holder. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screw-