Hoover FH51000 Product Manual - Page 19

Cleaning Upholstery - replacement hose

Get Hoover FH51000 PDF manuals and user guides View all Hoover FH51000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

After Using Tool 4.6 Drain suction hose by turning cleaner ON and holding nozzle up for several minutes. Do not press trigger. ! CAUTION ! Always turn off appliance before connecting or disconnecting hose. Disconnect hose and solution tube from cleaner. Drain solution tube by placing round end in sink and raising the trigger end at the hose nozzle above your head (4.6). Press the trigger to release air and fluid. Replace Hose and tools in the Mesh Storage Bag. 4.6 Cleaning upholstery Read "Before You Begin Cleaning" instructions. Be sure to check Hoover Cleaning Guide on page 6 and the cleaning code on your upholstery. Use your cleaner only on upholstery marked "W" or "W/S". 1. Attach hose and solution tube as instructed. 2. Place handle in upright position. Brushes will not rotate while handle is in upright position. 3. Fill Clean Water Tank according to instructions on (Pg. 7). 4. Attach tool to end of hose. 5. Dry hands and plug cleaner into a properly grounded outlet. 6. Turn cleaner ON. 7. 4.7 Gently press the tool onto the fabric. Press the trigger and slowly pull the nozzle over the fabric. 8. Overlap strokes by 1/2 inch to help prevent streaking. 9. Make additional strokes without pressing the trigger to remove more solution. To clean in corners or creases, lift the tool one half inch from the fabric and press the solution trigger. 10. 4.8 For heavily soiled areas, it may be necessary to repeat the cleaning process. Make crisscrossing strokes to the original pattern; overlap each pass. Make no more than 2 passes with the solution over any one area to prevent over-wetting and damage to fabric. 11. For best cleaning results, Hoover recommends to rinse the upholstery with water only. This will remove 4.7 4.8 residual cleaning solution from your upholstery. Simply fill your clean water tank with water only and repeat steps 7 and 8. If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again. Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in suction (see "Automatic Shut-Off"). When finished cleaning, follow "After Cleaning" and "After Using Tool" instructions. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
10
After Using Tool
4.6 Drain suction hose by turning cleaner ON and
holding nozzle up for several minutes. Do not
press trigger.
4.6
Disconnect hose and solution tube from cleaner.
Drain solution tube by placing round end in sink
and raising the trigger end at the hose nozzle
above
your
head
(
4.6
).
Press
the
trigger
to
release air and fluid.
Replace
Hose
and
tools
in
the
Mesh
Storage
Bag.
CAUTION
!
!
Always turn off appliance before connecting or
disconnecting hose.
CLEANING UPHOLSTERY
Read “Before You Begin Cleaning” instructions.
Be sure to check Hoover Cleaning Guide on page 6 and the
cleaning code on your upholstery. Use your cleaner only on
upholstery marked “W” or “W/S”.
1. Attach hose and solution tube as instructed.
2. Place handle in upright position. Brushes will not rotate
while handle is in upright position.
3. Fill Clean Water Tank according to instructions
on (Pg. 7).
4. Attach tool to end of hose.
5. Dry hands and plug cleaner into a properly
grounded outlet.
6.
Turn cleaner ON.
7.
4.7
Gently press the tool onto the fabric. Press the
trigger and slowly pull the nozzle over the
fabric.
8.
Overlap strokes by 1/2 inch to help prevent
streaking.
9.
Make additional strokes without pressing the
trigger to remove more solution.
To clean in corners or creases, lift the tool one
half inch from the fabric and press the solution
trigger.
10.
4.8
For heavily soiled areas, it may be necessary
to
repeat
the
cleaning
process.
Make
crisscrossing strokes to the original pattern;
overlap each pass.
Make no more than 2 passes with the solution
over any one area to prevent over-wetting and
damage to fabric.
11. For best cleaning results, Hoover
recommends to
rinse the upholstery with water only. This will remove
4.7
4.8
residual cleaning solution from your upholstery.
Simply fill your clean water tank with water
only and repeat steps 7 and 8.
If additional cleaning is necessary, wait until the upholstery
is completely dry before using the tool again.
Empty Dirty Water Tank when the motor sound becomes
higher pitched and there is a loss in suction (see
“Automatic Shut-Off”).
When finished cleaning, follow “After Cleaning” and “After
Using Tool” instructions.