Husqvarna TS142L Owner Manual - Page 15
CAUTION, To use the throttle control, To use the choke control, To use the cruise control, To use
View all Husqvarna TS142L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
CAUTION: The exhaust gas from the warm engine can cause burn damage to the grass. To prevent burn damage , to the grass, always stop the engine when you stop the product on grass areas. 1. Push down on the brake pedal (A) fully until the product stops fully. A 2. Disengage the cutting deck. Refer to To engage and disengage the cutting deck on page 16. 3. Put the throttle control in the slow position and let the engine operate at idle speed for some minutes. 4. Put the cutting deck in the transport position. Refer to To set the cutting deck in transport position or mow position on page 14. 5. Turn the ignition key to the "STOP" position and remove the ignition key from the ignition. A 1. Pull the knob (A) out to engage the choke control. 2. Push the knob (A) slowly to disengage the choke control. To use the cruise control Only use the cruise control for forward travel on smooth, straight surfaces. The cruise control will disengage automatically if the conditions for cruise control become unsatisfactory. 1. Push the forward drive pedal (B) down. Keep the forward drive pedal in a position that gives the correct speed for the terrain. B A To use the throttle control The operating efficiency of the engine decreases when the engine operates at less than full speed. Full speed gives the best mower performance. • Set the throttle control (A) to the "FULL" position to operate the engine at full speed. A 2. Pull the cruise control lever (A) up and hold it while you release the forward drive pedal. 3. Release the cruise control lever to engage the cruise control. 4. Push the brake pedal or tap on the forward drive pedal to disengage the cruise control. To use the headlight • Push the power switch to position (A) to make the headlight come on. B A To use the choke control Note: Use the choke control to start a cold engine. Do not use the choke control to start a warm engine. • Push the power switch to position (B) to make the headlight go off. 1958 - 002 - 12.10.2022 15