Icom IC-M604A Instruction Manual - Page 62
into the [COMMAND MIC-1] or [COMMAND MIC-2], HM-157/HM162 installation Continued
View all Icom IC-M604A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
9 CONNECTIONS AND MAINTENANCE ■ HM-157/HM162 installation (Continued) q Insert the supplied cable (or HM-157 without the cable) into the [COMMAND MIC-1] or [COMMAND MIC-2] connector and tighten the cable nut as shown below. • Up to two COMMANDMIC™s can be connected simultaneously. • The HM-157 and HM-162 can be connected at the same time. t Install the mounting base using the supplied screws as shown below. • HM-157 Mounting base Nut [COMMAND MIC-2] [COMMAND MIC-1] w To use the supplied cable as a wall socket, perform the following steps. e Using the mounting base as a template, carefully mark the holes where the cable and three screws will be fastened. r Drill holes at these marks. Gasket Screw holes Cap (approx. 2 (d) mm; 3 32″) Completed • HM-162 Mounting base Nut Gasket Screw holes (approx. 2 (d) mm; 3 32″) Cap Completed 56