Icom IC-PW1 Instruction Manual - Page 12

2 INSTALLATION AND CONNECTIONS • Using 1 Icom and 1 non-Icom exciters (transceivers) NOTE: The specifications for the SEND relay are 5 V DC 0.1 A. If this level is exceeded, a large external relay must be used. To an ACC-1 antenna ANT REMOTE Be sure to connect the cable to the 7-pin ACC(2) jack. ACC cable (supplied) Remote control cable (supplied) Coaxial cable (supplied) INPUT1 INPUT2 GND ACC(2) Connect ANT1 or ANT2 REMOTE IC-756 EXCITER 1 1&2 GND Non-Icom exciter ANT IC-PW1 AC outlet Coaxial cable Ground (optional) (Non-Europe versions : 100-120/220-240 V Europe version : 230 V) SEND SEND2
SEND RF OUT GND SEND DC OUT ALC ALC2 RCA plug Relay DC power ALC • Using non-Icom exciters (transceivers) when the IC-PW1's power is OFF To use the antenna selector of the IC-PW1 when the IC-PW1 power is OFF, follow 1 of 2 methods. (1) Supply the antenna selector power to the ACC-1 socket Supply the 13.8 V DC, 0.5 A to pin 7 of the [ACC-1]/[ACC-2] socket. - Use [ACC-1] when the exciter is con- nected to [INPUT1]. - Use [ACC-2] when the exciter is con- nected to [INPUT2]. to IC-PW1 [INPUT1] 13.8 V DC [ACC-1] to IC-PW1 [GND] 6 3 1 RF GND 524 DC SEND ALC IC-PW1 (DIN) Non-Icom exciter (2) Use the auxiliary power supply Set the jumper to '2' to use the auxiliary power supply as shown at right. - The antenna selector functions even when the IC-PW1 power is OFF In addition set the jumper on the IC-PW1 controller to '2' to turn the controller's LEDs OFF as shown at right. When the jumper is set to '2,' the CI-V control does not function even if an Icom exciter is connected. •Jumper location of linear amplifier S3 J3 J4 2 1 • Jumper location of controller 12 These diagrams show the factory defaults. 9