Icom IC-PW1 Instruction Manual - Page 13
Separating the remote controller
View all Icom IC-PW1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
2 INSTALLATION AND CONNECTIONS s Separating the remote controller The control section of the linear amplifier can be separated from the main body, doubling as a remote controller. It can be placed on the exciter or in another convenient place. q Disconnect the AC power cable. w Remove 8 screws from the sides of the linear am- plifier, then lift up the top cover. y Replace the control cable with the supplied separation cable through the cable hole. Use the shorter end (from the bushing) to connect to the remote controller. Control cable JACK unit MAIN unit (Fig. 1) e Unplug the control cable from J3 on the MAIN unit. Control cable (step i) J3 Separation cable u Remove 2 screws from the cable hole cover on the linear amplifier rear panel. Insert the separation cable into the cable hole. Keep the hole cover and screws for future use. CONTROLLER Longer end (from the bushing) Control cable (step e) (Fig. 2) r Remove 2 screws from the front panel of the linear amplifier, then detach the remote controller. (Fig. 1) Attach the dummy panel onto the space left by the controller using the 2 screws. t Remove 5 screws from the rear panel of the remote controller, then remove the rear panel. i Plug the other longer end (from the bushing) of the separation cable into J10 on the JACK unit through the cable hole. Connect the grounding wire as shown below. Connect the control cable to J11. Control cable J11 To J3 J10 (MAIN) Separation cable JACK unit o Plug the other end of the control cable into J3 on the MAIN unit. (Fig. 2) !0 Replace the top cover and 8 screws. 10