Icom IC-PW1 Instruction Manual - Page 6

1 PANEL DESCRIPTION s Rear panel q w e r t y u i ANT4 ANT3 ANT2 ANT1 ACC-2 ALC2 SEND2 ACC-1 CONTROLLER REMOTE ALC adj2 ALC1 SEND1 EXCITER 1 1&2 REMOTE ALC adj1 L N INPUT1 !1 INPUT2 !0 o q OUTPUT ANTENNA CONNECTORS [ANT1] - [ANT4] (p. 6) Accept a 50 Ω antenna with a PL-259 connector. w ACCESSORY SOCKET-1 [ACC-1] ACCESSORY SOCKET-2 [ACC-2] Enable connection to Icom exciters (transceivers). - See the page at right for socket information. - The [ACC-2] socket is connected in parallel with [ACC-1] by default and can be used for connecting external equipment such as the EX-627 AUTOMATIC ANTENNA SELECTOR, etc. These sockets can be separated by the [EXCITER] switch. (!0) e REMOTE CONTROLLER CABLE HOLE [CONTROLLER] (p. 10) Used for separation of the remote controller and linear amplifier. r ALC OUTPUT JACKS [ALC1]/[ALC2] (p. 11) Connect to the ALC input jack of a non-Icom exciter (transceiver). - Control voltage: -10 to 0 V DC t SEND CONTROL JACKS [SEND1]/[SEND2] (pgs. 8, 9) Input terminals for transmit control. Go to ground while transmitting. - Max. control level: 5.0 V DC/0.1 A - Ground level: -0.5 to 0.8 V DC y CI-V REMOTE CONTROL JACKS [REMOTE] (pgs. 7-9) Used for band control with an Icom CI-V exciter (transceiver). u ALC LEVEL ADJUSTMENT POTS [ALC adj1]/[ALC adj2] (p. 11) Adjust the ALC levels. RCAUTION! DO NOT operate the IC-PW1 be- fore adjusting the [ALC adj1] and [ALC adj2] pots properly. This may damage the final FETs. i CIRCUIT BEAKERS (p. 14) Cut off the AC input when over current occurs. - Circuit breaker capacity: 20 A (U.S.A. version) 15 A (Europe version) o GROUND TERMINAL (p. 6) Connect this terminal to a ground to prevent electrical shocks, TVI, BCI and other problems. 3