Icom IC-PW1 Instruction Manual - Page 8

2 INSTALLATION AND CONNECTIONS s Unpacking After unpacking, immediately report any damage to the delivering carrier or dealer. Keep the shipping cartons. For a description and a diagram of accessory equipment included with the IC-PW1, see UNPACKING on p. ii of this manual. s Ferrite core installation The supplied ferrite core and cable clips (o and !0 in UNPACKING) should be attached to the AC cable of the IC-PW1 as illustrated below. This will help prevent interference such as TVI, etc. Attach and position the cable clips to the AC cable as illustrated. AC cable Ferrite core Cut the cable clips so that enough length remains to secure the ferrite core in place. s OPC-853 AC cable with line filter The IC-PW1 Europe version must be used with the OPC-853 AC cable to satisfy European EMC requirements. s AC power cable connection A suitable AC power plug must be connected to the AC power cable end. See the diagram below for connection procedures. AC input voltage is automatically selected. The IC-PW1 can accept either 100-120 V AC or 200-240 V AC power.* However, we recommend using 200-240 V AC rather than 100-120 V AC for better power supply efficiency and longer periods of transmission. * Europe version: 230 V AC only s Selecting a location Select a location for the linear amplifier that allows adequate air circulation, free from extreme heat, cold, or vibrations, and away from TV sets, TV antenna elements, radios and other electro-magnetic sources. The linear amplifier and remote controller sections of the IC-PW1 can be separated. The remote controller can be placed near the operator for easy monitoring of linear amplifier conditions at any time. See p. 10 for separation instructions. The linear amplifier must be placed on a solid foundation since it is very heavy. •AC power cable connection (Except Europe version) (1) Single-phase 3-wire line (200-240 V AC) q The green wire from the AC power cable must be connected to the protective earth. w The black and white wires from the AC power cable can be connected to either terminal. *Use the appropriate AC plug if required. * white black green (2) Single-phase 2-wire line (100-120 V AC) q The green wire from the AC power cable must be connected to the protective earth. w The black wire from the AC power cable must be connected to the hot (live) wire. e The white wire from the AC power cable must be connected to the return wire. GND white black green (3) Three-phase 3-wire line (200-240 V AC) q The green wire from the AC power cable must be connected to the protective earth. w The black and white wires from the AC power cable can be connected to 2 of 3 wires. white black green 5