Icom IC-R8600 Ci-v Reference Guide - Page 15

Remote control DDCommand formats (Continued) Memory channel content Command: 1A 00 For receiving a DCR signal $2 $3, $4 $5 $6 ~ $8 XXXXXXXXXXXXXX $2 Digital squelch (D.SQL) type $2 0X 0 (Fixed) 0 = OFF 1 = UC $3, $4 UC code $3 $4 0XXX Once position: 0 ~ 9 10th position: 0 ~ 9 100th position: 0 ~ 5 0 (Fixed) $5 Encryption setting $5 0X 0 (Fixed) 0 = OFF 1 = ON $6 ~ $8 Encryption key $6 $7 $8 0XXXXX Once position: 0 ~ 9 10th position: 0 ~ 9 100th position: 0 ~ 9 1000th position: 0 ~ 9 10000th position: 0 ~ 3 0 (Fixed) Command 1A 00 clears a memory channel by sending the command in the following format. q, w : 0000 ~ 0101 group  You cannot specify group "0102" (Program scan edge) e, r : Memory channel number t : "FF" y ~ : None Programmable scan start (remote) data Command: 1A 0B 00 q～t y～!0 !1、!2 !3 X X ...... X X X X ...... X X X X X X X X !～4 !7 !8、!9 @0、@1 @2 @3 X X ...... X X X X X X X X X X X X X X @4 @5 XXXX q ~ t Lower scan edge Refer to "Receiving frequency" (p. 9) y ~ !0 Higher scan edge Refer to "Receiving frequency" (p. 9) !1, !2 Receiving mode Refer to "Receiving mode" (p. 9) !3 Duplex setting Refer to "Duplex setting (!3)" (p. 11) !4 ~ !7 Offset frequency Refer to "Offset frequency" (p. 9) !8, !9 Tuning step Refer to "Tuning step (!8, !9)" (p. 11) @0, @1 Programmable tuning step Refer to "Programmable tuning step (@0, @1)" (p. 11) @2 Attenuator setting Refer to "Attenuator setting (@2)" (p. 11) @3 Preamplifier setting Refer to "Preamplifier setting (@3)" (p. 11) @4 Antenna setting Refer to "Antenna setting (@4)" (p. 11) @5 IP plus (IP+) function Refer to "IP plus (IP+) function (@5)" (p. 11) 14