Icom IC-R8600 Ci-v Reference Guide - Page 25

Remote control DDCommand formats (Continued) DCR RX ID Command: 20 0C01, 20 0C02 q, w e ~ y XXXX 0 X 0 X0 X 0 X u ~ !0 0 (Fixed) !1, !2 0 X 0 X 0 X 0 X0 XXX 0 (Fixed) qHeader flag data (First byte) Data Description bit7 0 (Fixed) - bit6 0 (Reserved) bit5 0 (Reserved) bit4 0 (Reserved) bit3 bit2 See the table below Type of call bit1 0/1 0=Encryption OFF, 1=Encryption ON bit0 0 (Reserved) Data bit3 bit2 1 1 All call 1 0 Group call 0 1 Individual call 0 0 Not identified Description wHeader flag data (Second byte) Data Description bit7 0 (Fixed) - bit6 0 (Reserved) bit5 0 (Reserved) bit4 0 (Reserved) bit3 0 (Reserved) bit2 0 (Reserved) bit1 0 (Reserved) bit0 0 (Reserved) e ~ y: ID of the CALLER station (4 digits in Hexer decimal) u ~ !0: ID of the CALLED station (4 digits in Hexer decimal) !1, !:2 UC (3 digits in decimal) LIf the UC, CALLER or CALLED station is not identified, "FF" is returned. LFF: N o signal has been received since the power was turned ON. DCR RX Status data Command: 20 0D01, 20 0D02 Data Function bit7 0 (Fixed) bit6 0/1 - bit5 0/1 - bit4 0/1 Receive status bit3 0/1 Last call finisher bit2 0/1 Receiving a signal bit1 0/1 Interfere detection bit0 0/1 Encryption Description - (Reserved) (Reserved) While receiving a DCR signal, "1" is returned. (Regardless of UC) When the last call was finished by a user, "1" is returned. When the audio tone can be heard, "1" is returned. While under an interference (Mode icon DCR and FM alternately blink), "1" is returned. When the call is encrypted, "1" is returned. D-STAR RX data (transceive) Command: 22 0101 q ~ #0 X X X X q ~ #0:Rx data (Up to 30 Bytes) L"FA" to "FF" are entered after converted to "FF 0A" to "FF 0F" automatically. In this case, the data length can be up to 60 Bytes. Selected or unselected VFO frequency Command: 25 XXXXXXXXXXXX Refer to the receive frequency data 00: Fixed 24