Insignia NS-FWM45W3 User Guide - Page 23
Step 4: Leveling your washer, CAUTIONS
View all Insignia NS-FWM45W3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
INSTALLATION INSTRUCTIONS NS-FWM45W3 Step 4: Leveling your washer CAUTIONS: If your washer isn't level, it may: • Vibrate excessively which can cause your washer to malfunction • Make excessive noise 1 Make sure that the legs are flush with the washer cabinet. If needed, use a wrench to loosen the lock nut on a leg, slide the leg up, then tighten the bolt. 2 Carefully move your washer to its final location. Gently rock your washer into position ensuring inlet hoses do not become kinked. It may be helpful to spray window cleaner on the floor to help move your washer into its final position. CAUTIONS: • It is important not to damage the rubber leveling legs when moving your washer to its final location. Damaged legs can increase washer vibration. • Do not use the dispenser drawer or door to lift your washer. 3 Press the four top corners of your washer. If your washer moves when you press a corner, the leg for that corner needs to be adjusted. 4 Loosen the lock nut on the bottom of your washer, pull the leg down until it touches the floor, then tighten the nut. Extend the feet only as much as is necessary. If the feet are extended too much, your washer may vibrate. 5 Press the four corners again to make sure that your washer is level. If your washer is still not level, repeat step 4. 6 Use a level to make sure that all four sides of your washer are level. www.insigniaproducts.com 23