Insignia NS-FWM45W3 User Guide - Page 43

USER MAINTENANCE INSTRUCTIONS NS-FWM45W3 PROBLEM POSSIBLE CAUSE SOLUTION The wash tub This is normal. does not fill with water. • Front load washers do not require the tub to fill with water like top-load washers. The pump is clogged. • See Cleaning the pump filter on page 36 on how to clean the pump filter. You can't open the door if My washer pauses your washer is running. or has to be restarted, or the washer door is locked and will not open. • Press the Start/Pause button for three seconds. When the washer drum has stopped, open the door and add clothing. Close the door, then press the Start/Pause button again to restart the load. Note: Don't use the pause function when the water surface is over the edge of the inner tub or when the temperature is too hot. • If the door is locked when your washer isn't running, unplug the power cord, then plug it back in. This is normal. The door unlocks or when I press the Start/Pause button my washer doesn't operate. Incorrect operation. • Front-load washers start up differently than top-load washers, and it takes 30 seconds to check the system. During this time, the door will lock and unlock automatically. • Open and close the door firmly, then press the Start/Pause button. Automatic system self-checks. • After Start/Pause is pressed, your washer does several system checks. Water will normally flow 60 seconds after Start/Pause is pressed. Water does not Water supply is turned off. enter my washer or enters slowly. Water supply hose screens are clogged. • Turn on the water supply. • Turn off the water source and remove the water supply hoses from the back of your washer. Use a brush or toothpick to clean the screens in your washer. Reconnect the hose and turn the water back on. www.insigniaproducts.com 43