Intel D845HV Product Guide - Page 14
USB Support, PCI Enhanced IDE Interface, Expansion Slots, PIO Mode 3 and PIO Mode 4 devices - drivers
View all Intel D845HV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Intel Desktop Boards D845HV and D845WN Product Guide USB Support ✏ NOTE Computer systems that have an unshielded cable attached to a USB port might not meet FCC Class B requirements, even if no device or a low-speed USB device is attached to the cable. Use a shielded cable that meets the requirements for a full-speed USB device. The boards support up to seven USB 1.1 ports via the ICH2 and I/O controller; four ports routed to the back panel, two to the front panel connector, and one to the optional CNR. To attach additional devices, connect an external hub to either of the built-in ports. The board supports the standard universal host controller interface (UHCI) and takes advantage of standard software drivers written to be compatible with UHCI. PCI Enhanced IDE Interface The ICH2's IDE interface handles the exchange of information between the processor and peripheral devices like hard disks, CD-ROM drives, and Iomega Zip† drives inside the computer. The interface supports: • Up to four IDE devices (such as hard drives) • ATAPI devices (such as CD-ROM drives) • PIO Mode 3 and PIO Mode 4 devices • Ultra DMA-33 and ATA-66/100 protocols • Laser servo (LS-120) drives Expansion Slots The D845HV and D845WN boards have the following add-in card connectors: The D845HV board has: • Three PCI bus add-in card connectors (PCI bus connector 3 slot shared with CNR) • One AGP connector • One optional CNR connector (slot shared with PCI bus connector 3) The D845WN board has: • Six PCI bus add-in card connectors (PCI bus connector 6 slot shared with CNR) • One AGP connector • One optional CNR connector (slot shared with PCI bus connector 6) 14