Intel D845HV Product Guide - Page 36
Connecting the IDE Cable, shows
View all Intel D845HV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Intel Desktop Boards D845HV and D845WN Product Guide Connecting the IDE Cable The Intel® boxed desktop board package includes two IDE cables. Both are capable of connecting two drives to the desktop board. The 40-contact cable supports the Ultra DMA-33 transfer protocol. The 40-contact, 80-conductor cable supports ATA-66 and ATA-100 transfer protocols and is backward compatible with drives using slower IDE transfer protocols. Figure 16 shows the correct installation of the cable. ✏ NOTE ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer protocols. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are attached to the same cable, the maximum transfer rate between the drives may be reduced to that of the slowest drive. ✏ NOTE Do not connect an ATA device as a slave on the same IDE cable as an ATAPI master device. For example, do not connect an ATA hard drive as a slave to an ATAPI CD-ROM drive. For correct function of the cable: • Attach the cable end with the single connector to the board. • Attach the cable end with the two closely spaced connectors to the drives. B A OM11988 Figure 16. Connecting the IDE Cable 36