Intel D865GSA Product Specification - Page 38

LAN Subsystem

Page 38 highlights

Intel Desktop Board D865GSA Technical Product Specification 1.8 LAN Subsystem The LAN subsystem consists of the following: • Realtek RTL8100C 10/100 Mbits/sec Ethernet LAN controller • RJ-45 LAN connector with integrated status LEDs • Programmable transit threshold • Configuration EEPROM that contains the MAC address • PCI power management ⎯ Supports ACPI technology ⎯ Supports LAN wake capabilities 1.8.1.1 RJ-45 LAN Connector with Integrated LEDs Two LEDs are built into the RJ-45 LAN connector (shown in Figure 7 below). Green LED Yellow LED OM18307 Figure 7. LAN Connector LED Locations Table 11 describes the LED states when the board is powered up and the 10/100 Mbits/sec LAN subsystem is operating. Table 11. LAN Connector LED States LED Color LED State Condition Green Off LAN link is not established. On LAN link is established. Blinking LAN activity is occurring Yellow Off 10 Mbits/sec data rate is selected. On 100 Mbits/sec data rate is selected. 1.8.2 LAN Subsystem Software LAN software and drivers are available from Intel's World Wide Web site. For information about Obtaining LAN software and drivers Refer to Section 1.2, page 15 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94

Intel Desktop Board D865GSA Technical Product Specification
38
1.8
LAN Subsystem
The LAN subsystem consists of the following:
Realtek RTL8100C 10/100 Mbits/sec Ethernet LAN controller
RJ-45 LAN connector with integrated status LEDs
Programmable transit threshold
Configuration EEPROM that contains the MAC address
PCI power management
Supports ACPI technology
Supports LAN wake capabilities
1.8.1.1
RJ-45 LAN Connector with Integrated LEDs
Two LEDs are built into the RJ-45 LAN connector (shown in Figure 7 below).
Green LED
Yellow LED
OM18307
Figure 7.
LAN Connector LED Locations
Table 11 describes the LED states when the board is powered up and the
10/100 Mbits/sec LAN subsystem is operating.
Table 11. LAN Connector LED States
LED Color
LED State
Condition
Off
LAN link is not established.
On
LAN link is established.
Green
Blinking
LAN activity is occurring
Off
10 Mbits/sec data rate is selected.
Yellow
On
100 Mbits/sec data rate is selected.
1.8.2
LAN Subsystem Software
LAN software and drivers are available from Intel’s World Wide Web site.
For information about
Refer to
Obtaining LAN software and drivers
Section 1.2, page 15