Intermec PX4i Industrial/Serial Interface Kit Installation Instructions - Page 12

rear plate., Connect the power cord and switch on the power.

Get Intermec PX4i PDF manuals and user guides View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Chapter 2 - Physical Installation • Connect the console cable to J50 on the CPU board and put back the cover over the electronics compartment. Take care so the console cable runs above the ribbon motor (if any) and does not become entangled in the headlift mechanism. • Connect the communication cables to the connectors on the printer's rear plate. • Connect the power cord and switch on the power. • Enter the Setup Mode to set the proper communication parameters for the serial communication channels "uart2:" and "uart3:". Industrial interface socket Serial interface socket "uart2:" 8 Serial/Industrial Interface Kit Installation Instructions

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
8
Serial/Industrial Interface Kit Installation Instructions
Chapter 2 — Physical Installation
•
Connect the console cable to J50 on the CPU board and put back the
cover over the electronics compartment. Take care so the console cable
runs above the ribbon motor (if any) and does not become entangled
in the headlift mechanism.
•
Connect the communication cables to the connectors on the printer’s
rear plate.
•
Connect the power cord and switch on the power.
•
Enter the Setup Mode to set the proper communication parameters
for the serial communication channels "uart2:" and "uart3:".
Serial interface
socket "uart2:"
Industrial interface
socket