Intermec PX4i Industrial/Serial Interface Kit Installation Instructions - Page 8
EasyCoder PF2/4i Printers
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Chapter 2 - Physical Installation EasyCoder PF2/4i Printers • Switch off the printer and disconnect the power cord. • Disconnect all communication cables. • Remove the front/left-hand cover as follows. The electronic compartment contains wires and components with dangerous voltage (up to 380V). Make sure that the printer is switched off and the power cord is disconnected before the left-hand cover is removed. • Open the right-hand door. • Using a #T20 Torx screwdriver, remove the three screws and lift the cover up so it disengages the bottom plate. • Swing out the rear part of the cover so you can disconnect the console cable from the CPU board. • Put the cover aside on a soft cloth or similar to avoid scratches. 4 Serial/Industrial Interface Kit Installation Instructions