Intermec PX4i Industrial/Serial Interface Kit Installation Instructions - Page 14

Attach the flat cable included in the kit to connector J62 marked

Get Intermec PX4i PDF manuals and user guides View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Chapter 2 - Physical Installation • Remove the two #T10 Torx screws that hold the cover plate. Always start with the inner one. Remove the cover plate. #T10 Torx screw Cover plate #T10 Torx screw • Save the cover plate for possible later use. Keep the screws. • Remove the #T20 Torx screw fitted on the hexagonal spacer at the center of the CPU board. Keep the screw. • If reconfiguration of the interface board is required, fit or remove circuits and straps according to the descriptions in Chapters 3 and 4. • Attach the flat cable included in the kit to connector J62 (marked "EXP BOARD") on the CPU board (see illustration on page 12). 10 Serial/Industrial Interface Kit Installation Instructions

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
10
Serial/Industrial Interface Kit Installation Instructions
Chapter 2 — Physical Installation
•
Remove the two #T10 Torx screws that hold the cover plate. Always
start with the inner one. Remove the cover plate.
•
Save the cover plate for possible later use. Keep the screws.
•
Remove the #T20 Torx screw fitted on the hexagonal spacer at the
center of the CPU board. Keep the screw.
•
If reconfiguration of the interface board is required, fit or remove
circuits and straps according to the descriptions in Chapters 3 and 4.
•
Attach the flat cable included in the kit to connector J62 (marked
“EXP BOARD”) on the CPU board (see illustration on page 12).
#T10 Torx screw
Cover plate
#T10 Torx screw