Intermec PX4i Industrial/Serial Interface Kit Installation Instructions - Page 9

circuits and straps according to the descriptions in s 3 and 4.

Get Intermec PX4i PDF manuals and user guides View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

Chapter 2 - Physical Installation • Remove the two #T10 Torx screws that hold the interface cover plate. Remove the cover plate. #T10 Torx screw Cover plate #T10 Torx screw • Save the cover plate for possible later use. Keep the screws. • Remove the #T20 Torx screw fitted on the hexagonal spacer at the CPU board. Keep the screw. • If reconfiguration of the interface board is required, fit or remove circuits and straps according to the descriptions in Chapters 3 and 4. • Attach the flat cable included in the kit to connector J62 (marked "EXP BOARD") on the CPU board (see page 7). Serial/Industrial Interface Kit Installation Instructions 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Serial/Industrial Interface Kit Installation Instructions
5
Chapter 2 — Physical Installation
•
Remove the two #T10 Torx screws that hold the interface cover plate.
Remove the cover plate.
•
Save the cover plate for possible later use. Keep the screws.
•
Remove the #T20 Torx screw fitted on the hexagonal spacer at the
CPU board. Keep the screw.
•
If reconfiguration of the interface board is required, fit or remove
circuits and straps according to the descriptions in Chapters 3 and 4.
•
Attach the flat cable included in the kit to connector J62 (marked
“EXP BOARD”) on the CPU board (see page 7).
#T10 Torx screw
Cover plate
#T10 Torx screw