Intermec PX4i Industrial/Serial Interface Kit Installation Instructions - Page 21

°e flat cable should run as illustrated below., tor P1 on the interface board, as illustrated below.

Get Intermec PX4i PDF manuals and user guides View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Chapter 2 - Physical Installation • Installations of two boards: First install the inner board, then the outer one. Put the hexagonal spacer included in the kit between the inner and the outer interface board, and finally secure the outer board with the screw. • The kit contains two flat cables, one with two connectors for use with a single interface board and one with three connectors for use with double interface boards. Connect the appropriate flat cable to connector P1 on the interface board, as illustrated below. • The flat cable should run as illustrated below. $16#PBSE 4QBDFS FYJTUJOH $BCMF *OOFS*OUFSGBDF#PBSE 4DSFX FYJTUJOH $16#PBSE 4QBDFS FYJTUJOH $BCMF *OOFS*OUFSGBDF#PBSE 4QBDFS GSPNLJU 0VUFS*OUFSGBDF#PBSE 4DSFX FYJTUJOH • Put back the cover over the electronics compartment. • Connect the communication cables to the connectors on the printer's rear plate. Serial/Industrial Interface Kit Installation Instructions 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Serial/Industrial Interface Kit Installation Instructions
17
Chapter 2 — Physical Installation
•
Installations of two boards: First install the inner board, then the outer
one. Put the hexagonal spacer included in the kit between the inner
and the outer interface board, and finally secure the outer board with
the screw.
•
°e kit contains two flat cables, one with two connectors for use with
a single interface board and one with three connectors for use with
double interface boards. Connect the appropriate flat cable to connec-
tor P1 on the interface board, as illustrated below.
•
°e flat cable should run as illustrated below.
•
Put back the cover over the electronics compartment.
•
Connect the communication cables to the connectors on the printer’s
rear plate.