Invacare CRFTI Owners Manual - Page 50

Adjusting the Camber Tube, may occur.

Get Invacare CRFTI PDF manuals and user guides View all Invacare CRFTI manuals
Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

SECTION 8-WHEELS Adjusting the Camber Tube ƽ WARNING STANDARD and axle tube clamps - Make sure the hex screws are securely tightened before using the wheelchair, otherwise injury or damage to the wheelchair may occur. NOTE: For this procedure, refer to FIGURE 8.12. Stand behind the wheelchair to determine left or right. 1. Loosen, but DO NOT remove the four socket screws camber tube clamps. 2. Using an ʺLʺ square, rotate the axle tube until the flat edge of the camber tube is at a 90° angle with the ground/floor. 3. Securely tighten the four socket screws camber tube clamps. 4. Determine the toe in/toe out of the wheelchair. Refer to Adjusting Wheelbase Length (Adjusting Center of Gravity) on page 44. Flat Edge of Camber Tube (Place "L" Square Here) "L" Square Here (90° Angle) Ground/ Floor FIGURE 8.12 Adjusting the Camber Tube Crossfire™Series Wheelchairs 50 Part No 1134872

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
SECTION 8—WHEELS
Crossfire
™
Series Wheelchairs
50
Part No 1134872
Adjusting the Camber Tube
±
WARNING
STANDARD and axle tube clamps - Make sure the hex screws are securely tight-
ened before using the wheelchair, otherwise injury or damage to the wheelchair
may occur.
NOTE: For this procedure, refer to FIGURE 8.12.
Stand behind the wheelchair to determine left or right.
1.
Loosen, but DO NOT remove the four socket screws camber tube clamps.
2.
Using an
ʺ
L
ʺ
square, rotate the axle tube until the flat edge of the camber tube is at a
90° angle with the ground/floor.
3.
Securely tighten the four socket screws camber tube clamps.
4.
Determine the toe in/toe out of the wheelchair. Refer to Adjusting Wheelbase Length
(Adjusting Center of Gravity)
on page 44.
FIGURE 8.12
Adjusting the Camber Tube
Ground/
Floor
Flat Edge of Camber Tube
(Place “L” Square Here)
“L” Square Here
(90° Angle)