Invacare TDXSP Owners Manual 3 - Page 31

5 USAGE 5.3 Operating Powered Seating Systems ƽ GENERAL WARNINGS Refer to A Note About Drive Lock-Out on page 30 before performing this procedure. Pinch points may occur when returning the seat from any tilted position to the full upright position or when lowering the elevating seat. Make sure the hands and body of both the occupant and attendants/bystanders are clear of all pinch points before returning the seat to the full upright position or lowering the elevating seat. NEVER operate the wheelchair while the back is in any tilted/back angle position over 20° relative to the vertical position. If the drive lock-out does not stop the wheelchair from operating in a tilt/back angle position over 20° relative to the vertical position, DO NOT operate the wheelchair. DO NOT attempt to adjust the drive lock-out. Have the wheelchair serviced by a qualified technician. Use caution when driving in a tilted position. DO NOT operate the seating system while on an incline. DO NOT operate seating system while the wheelchair is moving. DO NOT operate the tilt function near or under a fixed object such as a table or desk. ACTUATOR CONTROL WARNING Use only the actuator controls listed in the following chart to activate the tilt/recline/elevate functions. DO NOT USE any other actuator controls. Such devices may result in excess heating and cause damage to the actuator and associated wiring and could cause a fire, death, physical injury or property damage. If such devices are used, Invacare shall not be liable and the limited warranty is void. SYSTEM TYPE Single Actuator (Tilt Only) JOYSTICK MK6i SPJ+ w/PSS MK6i SPJ+ w/ACC CMPJ+ POWERED SEATING CONTROL 4 POLE MOTOR SWITCH OPTION THROUGH THE JOYSTICK (TTJ) Powered Seating Switch No Yes Yes with SANODE Part No 1143192 31 Invacare® Adjustable ASBA Seats