Invacare TDXSP Owners Manual 3 - Page 50

5 USAGE  One of the following will occur when the drive lock-out feature has been activated: ƽ ƽ • CMPJ+ Joysticks Only - TILT WARNING or SPM Inhibited displays on the joystick or display unit. • SPJ+ Joysticks Only - Left to right chase alternating with a steady display. Drive lock-out is a feature designed to prevent the wheelchair from being driven after the seating system has been tilted beyond 20°* relative to the vertical position. This may affect the wheelchair user's line of sight while driving. Make sure the wheelchair user can see properly to ensure safe driving. *20° back angle can be any combination of tilt, back angle and/or surface angle. Tilt is a term used to define the angle between the seat rails and the ground/floor. To tilt the seat parallel back to the upright position, reverse the following procedure. 1. Place the wheelchair on a level surface. 2. Inform the occupant of the wheelchair that the wheelchair is about to be tilted and remind them to lean back. 3. Make sure the occupant's hands and body are clear of all pinch points. 4. Stand behind the wheelchair and grasp both release levers on the stroller handle. 5. Pull up on the two tilt release levers to disengage the manual tilt system. 6. Slowly, push down on the stroller handle while holding on the release levers in a continuous motion. 7. When the seat reaches the desired angle, slowly let go of the two release levers to engage the manual tilt system. Wheelchair Base Seat Assembly in Tilted Position Tilt (Right) Release Lever Seat Lock (Left) Release Lever Stroller Handle FIGURE 15 Operating the Manual Tilt Option (TDX Spree Only) Invacare® Adjustable ASBA Seats 50 Part No 1143192