JET Tools JWP-15HH User Manual - Page 6

4.0 Introduction This manual is provided by JET covering the safe operation and maintenance procedures for a JET Model JWP-15DX and JWP-15HH Planer. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or JET. JET can also be reached at our web site: www.jettools.com. 5.0 Specifications Model Number JWP-15DX JWP-15HH Stock Number 708538 708543 Maximum Cutting Width (in 14-7/8 14-7/8 Maximum Cutting Thickness (in 6 6 Full Width Cutting Depth (in 1/8 1/8 Maximum Cutting Depth (in 3/16 3/16 Minimum Planing Length (in 8 8 Number of Knives 3 68 knife inserts Cutterhead Speed (RPM 4,500 4,500 Cuts Per Minute 13,500 not applicable Cutterhead Diameter (in 2-7/8 2-7/8 Feed Rate (FPM 16 and 20 16 and 20 Dust Chute Diameter (in 4 4 Motor TEFC, 3HP, 1Ph, 230V, 60Hz TEFC, 3HP, 1Ph, 230V, 60Hz Overall Dimensions (LxWxH)(in 48 x 28 x 43-1/2 48 x 28 x 43-1/2 Net Weight (lbs 475 475 Gross Weight (lbs 590 590 The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. 6.0 Unpacking Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Planer is assembled and running properly. Compare the contents of your container with the following parts list to make sure all parts are intact. Report any missing parts to your distributor. Read this manual thoroughly for assembly, maintenance and safety instructions. 6.1 Contents of shipping container (see Figure 1 to help identify parts) 1 Planer 1 Dust Hood 2 Extension Tables 1 Handwheel 1 Handle 2 Magnet Tools - Model JWP-15DX only 4 Hex Wrenches (3,4,5 and 6mm) 1 T-handle Hex Wrench (4mm) - Model JWP- 15DX only 3 Open-end Wrenches (8-10, 12-14,14-17) 3 Bags of Fasteners (contents on page 7) 1 Owner's Manual 1 Warranty Card 6