JVC GD-V4200PZW GD-V4200PZW plasma display 32 page instruction manual (English - Page 21

ENGLISH Confirming the Use Time You can confirm the hours of use on the Setup Menu. This may be necessary when you ask for any service. 1 On the remote control: Press MENU/EXIT while holding VOLUME - to display the Setup Menu. On the Monitor: Press MENU while holding 2 to display the Setup Menu. Cursor (3) SET-UP MENU POWER SAVE : 1MIN. CONTROL LOCK : ON STATUS DISPLAY : ON SCREEN SAVER : ON WHITE BACK : ON VENTILATION MODE : H WHITE BALANCE all reset HOUR METER x100h : 001 ADJUST: SELECT: EXIT: MENU Hours of use 2 Confirm the hour of use. • The displayed value for the hours of use is divided by 100. To calculate the actual hours of use, multiply the displayed value by 100. 3 Press MENU/EXIT (or MENU on the Monitor) twice to exit from the menu operations. 3 Press 2/3 to select the desired amount of time. Select the number of minutes before the Monitor goes into standby mode after the signal has ceased to be supplied. Each time you press the button, the amount of time changes as follows: OFF 1 MIN. 2 MIN. 3 MIN. 4 MIN. 5 MIN. To cancel the Power Saving function, select "OFF." 4 Press MENU/EXIT (or MENU on the Monitor) twice to exit from the menu operations. Prohibiting the Monitor's Button Operations This function allows you to prohibit the button operations on the Monitor to prevent malfunction or avoid tampering. 1 On the remote control: Press MENU/EXIT while holding VOLUME - to display the Setup Menu. On the Monitor: Press MENU while holding 2 to display the Setup Menu. Notes: • The value for the hours of use is added by one hour unit. If you use the monitor within one hour. It will not be added to the hours of use. • The period when the monitor is on standby (the power lamp glows red) will not be added to the hours of use. Setting the Power Saving Function This function allows you to turn off (into standby mode) automatically when no signal comes in for a certain period of time. 1 On the remote control: Press MENU/EXIT while holding VOLUME - to display the Setup Menu. On the Monitor: Press MENU while holding 2 to display the Setup Menu. Cursor (3) SET-UP MENU POWER SAVE : 1MIN. CONTROL LOCK : ON STATUS DISPLAY : ON SCREEN SAVER : ON WHITE BACK : ON VENTILATION MODE : H WHITE BALANCE all reset HOUR METER x100h : 001 ADJUST: SELECT: EXIT: MENU 2 Press 5/∞ to move the cursor (3) to "POWER SAVE." Cursor (3) SET-UP MENU POWER SAVE : 1MIN. CONTROL LOCK : ON STATUS DISPLAY : ON SCREEN SAVER : ON WHITE BACK : ON VENTILATION MODE : H WHITE BALANCE all reset HOUR METER x100h : 001 ADJUST: SELECT: EXIT: MENU 2 Press 5/∞ to move the cursor (3) to "CONTROL LOCK." 3 Press 2/3 to select the desired setting. Each time you press the button, the Control Lock function alternates between "ON" and "OFF." To cancel the Control Lock function, select "OFF." 4 Press MENU/EXIT (or MENU on the Monitor) twice to exit from the menu operations. Note: • Even when the Control Lock function is in use, the following operations are possible: - Operation to cancel the Control Lock function - All operations from the remote control 21