JVC GD-V4200PZW GD-V4200PZW plasma display 32 page instruction manual (English - Page 27

ENGLISH SIZE/POSITION ADJ.* : See page 14. H.SIZE* H. POSITION* V. SIZE* V.POSITION* CLOCK PHASE* sub menu reset Adjusts the horizontal screen size. Adjusts the horizontal screen position. Adjusts the vertical screen size. Adjusts the vertical screen position. Adjusts to eliminate stripes or flickering. Normally, no adjustment is needed. Displays the fine adjustment bar. Resets Size/position Adjustment Menu settings to defaults. PICTURE ADJ. (Picture adjustment): See page 15. CONTRAST BRIGHT CHROMA** PHASE*** SHARPNESS sub menu reset Adjusts the contrast of the picture. Adjusts the brightness of the picture. Adjusts the color density of the picture. Adjusts the color phase. Adjusts the outlines of the picture. Displays the fine adjustment bar. Resets the Picture Adjustment Menu settings to defaults. FUNCTION SELECT: See pages 16 to 19. COLOR TEMP. ASPECT SIGNAL MODE reset Adjusts the color temperature. Use when the picture is reddish or bluish. Selects the horizontal to vertical ratio of the screen. • Selects a color system (NTSC, PAL, SECAM) when VIDEO A or VIDEO B input is selected. • Selects a scan system (480i, 576i, 480p, 720p, 1080i) when COMPONENT input is selected. Normally, set to "AUTO." Resets the Function Selection Menu settings to defaults. * Adjustment is only possible when RGB input is selected. ** Adjustment is not possible when RGB input is selected. *** Adjustment is only possible when viewing NTSC signal through the VIDEO A or B terminal. Setup Menu Setup Menu SET-UP MENU POWER SAVE : 1MIN. CONTROL LOCK : ON STATUS DISPLAY : ON SCREEN SAVER : ON WHITE BACK : ON VENTILATION MODE : H WHITE BALANCE all reset HOUR METER x100h : 001 ADJUST: SELECT: EXIT: MENU White Balance Adjustment Menu WHITE BALANCE:HIGH G GAIN B GAIN R GAIN sub menu reset : 000 :+ 001 :- 002 ADJUST: SELECT: EXIT: MENU all reset Are you sure? "YES" then press key. "NO" then press MENU key G GAIN - B GAIN - R GAIN - : 000 + :+001 + :-002 + reset Are you sure? "YES" then press key. "NO" then press MENU key POWER SAVE CONTROL LOCK STATUS DISPLAY SCREEN SAVER WHITE BACK VENTILATION MODE WHITE BALANCE all reset HOUR METER Sets the length of time before standby mode is automatically assumed after the input signal has stopped being supplied. (See page 21.) Sets the Monitor so that it cannot be operated with the buttons on itself. (See page 21.) Sets if you want the input terminal and the type of signal to be indicated on the screen just after inputs are switched. (See page 22.) Sets a screen saver. (See page 23.) Use to eliminate afterimages on the screen. (See page 22.) Adjusts the cooling fan speed according to the Monitor mounting method. (See page 23.) Adjusts R GAIN, G GAIN and B GAIN finely each for "HIGH" and "LOW" settings of the color temperature. (See page 17.) Resets the Setup Menu settings to defaults. (See page 23.) Use to confirm the hours of use. (See page 21.) 27