JVC SR-VS10U SR-VS10U dual transport MiniDV/S-VHS VTR 80 page instruction manu - Page 63
Reset The Counter, Vhs Deck Only, Locate Start Point, Engage Insert Editing, Start Editing, End
View all JVC SR-VS10U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
STOP INSERT A. DUB PLAY PAUSE C.RESET T 1 4 W 2 5 3 2 6 7 8 9 0 4 PLAY 1 DV VHS STOP PAUSE 3 JOG JOG/SHUTTLE SHUTTLE EN 63 RESET THE COUNTER (VHS deck only) 5 Press C.RESET to change the counter display to "0:00:00". LOCATE START POINT 6 Determine the edit-in point (the beginning of the segment to be replaced) using the JOG/SHUTTLE controls or pressing ™£ and PAUSE. ● Be sure to engage the Still mode at the edit-in point. ENGAGE INSERT EDITING 7 Press INSERT. ● Your VCR enters the Insert-Pause mode. ( , and light up on the front display panel.) ● The TV screen changes from the still picture to the input source you are going to record. 8 START EDITING Load the source cassette and play back the segment that is to be inserted. When you reach the start of the section of the source tape that you wish to insert, press PLAY to start the tape in your VCR; Insert Editing begins at this point. ● and are displayed on the front display panel. 9 END INSERT EDITING VHS deck At counter "0:00:00", Insert Editing will stop automatically while the tape continues running in the Play mode. If you wish to stop Insert Editing before the specified edit-out point, press C.RESET. DV deck Press STOP to stop the tape in the DV deck. FOR AV INSERT EDITING (VHS deck only) If you want to replace the picture, Hi-Fi audio soundtrack and normal audio soundtrack all at the same time... In step 7 above, after you press INSERT, press A. DUB. also. ( and blink and lights up on the display panel.) NOTES: ● Insert Editing cannot be performed on a VHS/S-VHS cassette that has had its record safety tab removed, or on a Mini DV cassette that has had its erase protection switch set to "SAVE". ● In insert editing, the recording speed (SP/EP) is determined by the previous recording to be replaced. If the previous recording's speed changes within a single edit, the inserted picture will be distorted at the switching point. (VHS deck only) ● A small portion of the recording which precedes an insert edit may become erased. ● Insert Editing is also possible using the rear connectors. When using these connectors, be sure to select the correct REAR AUX INPUT. To select the correct REAR AUX INPUT ("VIDEO" or "S-VIDEO"), follow steps 5 - 7 from the "Edit From A Camcorder" section, ੬ pg 57. ● Insert Editing is not possible using the DV IN/OUT connector.