JVC SR-VS10U SR-VS10U dual transport MiniDV/S-VHS VTR 80 page instruction manu - Page 79

SPECIFICATIONS GENERAL Power requirement : AC 120 V`, 60 Hz Power consumption Power on : 42 W Power off : 5.5 W Temperature Operating : 5°C to 40°C (41°F to 104°F) Storage : -20°C to 60°C (-4°F to 140°F) Operating position : Horizontal only Dimensions (WxHxD) : 437 mm x 127 mm x 390 mm (17-1/4" x 5" x 15-3/8") Weight : 7.5 kg (16.5 lbs) Input/Output : RCA connectors: (IN x 2, OUT x 2) S-Video connectors: (IN x 2, OUT x 2) DV connectors: (IN/OUT x 1) (4-pin, IEEE1394 conformity, digital input/output) DV playback component video connector: (OUT x 1) VHS DECK VIDEO/AUDIO Signal system : NTSC-type colour signal and EIA monochrome signal, 525 lines/ 60 fields Recording system : DA4 (Double Azimuth) head helical scan system Format : S-VHS/VHS NTSC standard Signal-to-noise ratio : 45 dB Horizontal resolution : 240 lines (VHS) 400 lines (S-VHS) Frequency range : 70 Hz to 10,000 Hz (Normal audio) 20 Hz to 20,000 Hz (Hi-Fi audio) Maximum recording time (SP) : 210 min. with ST-210 video cassette (EP) : 630 min. with ST-210 video cassette DV DECK VIDEO/AUDIO Signal system : NTSC-type colour signal, 525 lines/60 fields Recording system : Digital Component Recording Format : DV format (SD mode) Cassette : Mini DV Cassette Maximum recording time (SP) : 60 min. with M-DV60ME cassette (LP) : 90 min. with M-DV60ME cassette Audio recording system : PCM 48 kHz, 16 bit (2 ch)/ 32 kHz, 12 bit (4 ch) TUNER Tuning system Channel coverage VHF UHF CATV EN 79 : Frequency-synthesized tuner : Channels 2-13 : Channels 14-69 : 113 Channels TIMER Clock reference Program capacity Memory backup time : Quartz : 1-year programmable timer/ 6 programs each on the VHS and DV deck : Approx. 60 min. ACCESSORIES Provided accessories : RF cable (F-type), Infrared remote control unit, "AA" battery x 2, Audio/Video Cable, S-Video cable (4-pin), Power cord, Controller Specifications shown are for SP mode unless otherwise specified. E. & O.E. Design and specifications subject to change without notice. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.