JVC VN-H157WPU Instruction Manual - Page 66
Protocol continued, Set values, AMX Device Discovery, Protocol
![]() |
View all JVC VN-H157WPU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Internet Explorer Setting Settings (continued) Protocol Page (continued) B Protocol Settings (continued) HTTP Server Port You can change the port number for the built-in HTTP server of the camera. [Set values: 1 to 80 to 65535] Memo: ● To access the camera from Internet Explorer, enter the following in the Internet Explorer address bar when the camera is set to its default settings. http://192.168.0.2 If the port number has been changed to 8080, enter it after the IP address as follows. http://192.168.0.2:8080 Enter [:] and the port number ● If you change the HTTP server port, the port for the video stream deliver request also changes. HTTPS Server Port You can change the port number for the built-in HTTPS server of the camera. [Set values: 1 to 443 to 65535] Memo: ● To access the camera from Internet Explorer, enter the following in the Internet Explorer address bar when the camera is set to its default settings. https://192.168.0.2 If the port number has been changed to 8080, enter it after the IP address as follows. https://192.168.0.2:8080 Enter [:] and the port number ● If you change the HTTPS server port, the port for the video stream deliver request also changes. SNMP Sets SNMP. [Set values: ON, OFF] Memo: ● Refer to "About Corresponding MIB Information" (A Page 69). AMX Device Discovery Protocol You can change the AMX device discovery protocol. Set this to "ON" when using the camera with an AMX system. [Set values: ON, OFF] * The [Set values] in bold letters are factory defaults. 66
![](/manual_guide/products/jvc-vnh157wpu-instruction-manual-a680eb6/66.png)