JVC VN-H157WPU Instruction Manual - Page 73

Encoder No.1 to No.3 A Encoding B Framesize C Framerate Sets the manual streaming of Encoder No.1 to Encoder No.3. Displays the "Encode" being set for each encoder.(A Page 28) [Display values: JPEG, H.264 Baseline, H.264 High, MPEG4)] Displays the "Framesize" being set for each encoder. (A Page 27) Displays the "Framerate" being set for each encoder. (A Page 27) You can change it if the encoding is "JPEG". [Set values: 30 fps to 5 fps to 1/30 fps] Memo: ● You can change the frame rate if it is below the limit specified on the [Basic Setting2] page or on the [Encoding] page. D Destination Address E Destination Port F Start Sets a destination address for encoded data streaming. Set a multicast address. If you have another device for multicast streaming, set a different multicast address. [Factory default: Encoder No.1: 225.0.1.1, Encoder No.2: 225.0.2.1, Encoder No.3: 225.0.4.1] Sets a destination port number for encoded data streaming. Enter an even number to meet the RTP. If you have another device for multicast streaming, you should set a different port number. If a port number is duplicated, you cannot receive multiple number of multicast data using a single computer. [Factory default: Encoder No.1: 49152, Encoder No.2: 59152, Encoder No.3: 29152] Saves the encoder settings, and starts manual streaming. The [Stop] button is displayed during manual streaming. You cannot change the frame rate, destination address, and destination port during data distribution. Memo: ● When changing settings, press the [OK] button on the [Multicast] page to save the settings and then press the [Start] button to start multicast. Audio (VN-H57U/H257U/H257VPU/H157WPU only) G Destination Address Specifies the destination address for audio streaming. Specify a multicast address. When used with other multicast transmitting devices, set a separate multicast address for each device. [Factory default: 225.0.3.1] H Destination Port Specifies the destination port number for audio streaming. Specify an even number in accordance with RTP. When used with other multicast transmitting devices, it is recommended that you set a separate port number for each device. If the same port numbers are used, multiple multicasts will not be receivable on a single computer. [Factory default: 39152] I Start For starting and stopping manual distribution. * The [Set values] in bold letters are factory defaults. Memo: ● When the camera power source is cut during multicast streaming, the camera will restart multicast streaming automatically after the camera is restarted. ● Settings items A through F are displayed for each Encoder No. which has been activated. 73